To remedy this, either cut off both connectors and splice the wires (red to red, yellow to yellow, ground to ground, if I remember correctly) use the proper water tight butt connectors and crimping tools or purchase a D244 junction box with three male connectors, that would allow you to simply plug in the two female connectors and have expansion for a third. The seatalk connector end is female, as is the connector on your boat that use to plug into your ST60. On page 16 it shows an included adapter cable to plug into seatalk already provided. Confirm you don't have the close haul version.Īs for the rotating connector, there are two of them, they are used to connect to either NMEA-2000 or Seatalk. Note, on the website there is a note that the transducer connections are only on the i60 wind, not the i60 close haul wind. Maybe they are hidden behind a cover plate? Follow the link below, choose i60 English, and see the connectors in the diagram. I can see on page 20 there is a picture that shows where the spade connectors go. I don't own an i60 display, the advice that follows is from a quick read of the manuals.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |